|
Quicksep 1200
The consequent application of different physical laws in the separator
type QUICKSEP 1200 as well as the optimal combination of the suction
float and the pump is responsible for the very high separation
efficiency of these units.
The unwanted and free oils are thoroughly separated from all
contaminated fluids such as metal cutting emulsions, wash baths,
hardening baths etc. The clean medium from which the unwanted oils have
been separated flows back to the treatment tank by gravity. The
separation performance lies at over 98% when demulsifying fluids are
used.
The pump and the motor there are the only moving parts within the oil
separator Quicksep 1200. Therefore maintenance costs are reduced to a
minimum.
The standard execution of the oil separator QUICKSEP 1200 is delivered
completely with level indicator for fitting to a oil barrel in which
the separated oil is collected. A hydraulic dry run protection for the
pump (eccentric “MONO”-type pump only), as well as feed and return
tubes are included in the delivery.
For the aspiration in emulsion tanks a variety of suction floats are
available to suit specific requirements. A pre filter, air sparger
under the filter media bed, air operated membrane pump etc. are
available as options. All units are built for ambient temperature.
Special reinforced units for temperatures over 35°C up to 80°C are
available on special request.
Technical Specifications
Dimensions:
Width
Depth
Height
|
1500 mm (with pre filter)
850 mm
1830 mm
|
Volume:
Net weight:
|
500 litres
500 litres
|
Pumping capacity nominal:
Pumping capacity effective:
|
approx. 2000 l/h
approx. 1200 l/H
|
Drive:
electric
Option
|
3x400 Volt, 2,5 kW
Air operated membrane pump or peristaltic pump
|
|
