|
Quicksep 600
The consequent
application of different physical laws in the separator type QUICKSEP
600 as well as the optimal combination of the suction float and the
pump is responsible for the very high separation efficiency of these
units. The unwanted and free oils are thoroughly separated from all
contaminated fluids such as metal cutting emulsions, wash baths,
hardening baths etc. The clean medium from which the unwanted oils have
been separated flows back to the treatment tank by gravity. The
separation performance lies at over 98% when demulsifying fluids are
used.
Except for the pump
and the motor there are no moving parts within the oil separator
Quicksep 600. Due to this fact maintenance costs are reduced to a
minimum of rinsing the unit once or twice per year. The standard
execution of the oil separator QUICKSEP 600 is delivered completely
with oil tank with overflow protection, hydraulic dry run protection
for the pump (eccentric “MONO”-type pump only), as well as feed and
return tubes.
For the aspiration
in emulsion tanks a variety of suction floats are available to suit
specific requirements. A pre filter, air sparger under the filter media
bed, air operated membrane pump etc. are available as options. All
units are built for ambient temperature. Special reinforced units for
temperatures over 35°C up to 80°C are available on special request.
Technical Specifications
Dimensions:
Width
Depth
Height
|
1’200 mm, 1’500 mm
700 mm
1‘400 mm
|
(without pre filter)
(with pre filter)
|
Volume:
Net weight:
|
180 litres
180 litres
|
|
Pumping capacity nominal:
Pumping capacity effective:
|
approx. 600 l/h
approx. 1200 l/h
|
|
Drive:
electric
Option
|
3x400 Volt, 1,1 kW
Air operated membrane pump or peristaltic pump
|
|
