|
Quicksep 300
The consequent
application of different physical laws in the separator type QUICKSEP
300 as well as the optimal combination of the suction float and the
pump are responsible for the very high separation efficiency of these
units.
The unwanted and free
oils are thoroughly separated from all contaminated fluids such as
metal cutting emulsions, wash baths, hardening baths etc. The clean
medium from which the unwanted oils have been separated flows back to
the treatment tank by gravity. The separation performance lies at over
98% when demulsifying fluids are used.
Except for the pump and
the motor there are no moving parts within the oil separator Quicksep
300. Due to this fact maintenance costs are reduced to a minimum of
rinsing the unit once or twice per year. The standard execution of the
oil separator QUICKSEP 300 is delivered completely with oil tank with
overflow protection, hydraulic dry run protection for the pump
(eccentric “MONO”-type pump only), as well as feed and return tubes.
For the aspiration in
emulsion tanks a variety of suction floats are available to suit
specific requirements. A pre filter, air sparger under the filter media
bed, air operated membrane pump etc. are available as options. All
units are built for ambient temperature. Special reinforced units for
temperatures over 40°C up to 80°C are available on special request.
Technical Specifications
Dimensions:
Width
Depth
Height
|
700 mm, 960 mm
450 mm
1‘220 mm
|
(without pre filter)
(with pre filter)
(mobile execution)
|
Volume:
Net weight:
|
86 litres
approx. 70 kg
|
(mobile execution)
|
Pumping capacity nominal:
|
approx. 600 l/h |
|
Pumping capacity effective:
|
approx. 300 l/h
|
|
Drive:
electric
Option
|
3x400 Volt, 0,35 kW
Air operated membrane pump or peristaltic pump
|
|
